Cyclades AlterPath BladeManager Manual de instrucciones descargar pdf (Pagina 86)

72 MergePoint 5224/5240 Service Processor Manager Installer and Administrator Guide

3. Enter one or more comma-separated usernames in the Username field.

4. Enter one or more comma

-separated outlets to manage in the Outlets field.

5. Click OK.

6. Click Save and apply changes.

Configuring Names and Power Up Intervals for IPDU Outlets

After selecting the Settings - IPDU - Outlets tab, an administrative user can assign a name to a

power outlet and change power up interval (the number of seconds that must elapse between when

the selected outlet is turned on and another outlet is turned on).

Specify intervals using whole numbers along or followed by decimals, such as 10 or 7.5. Clicking

OK saves the entries.

To configure an alias and a power up interval for an IPDU outlet:

1. Select the Settings

- IPDU - Outlets menu option.

2. To assign or change an outlet name, perform the following steps:

a. Click the Edit button in the outlet’s Name column. The outlet name dialog appears.

b. Enter a name in the Outlet N name field.

c. Click OK.

3. To assign or change an outlet’s power

-up interval, perform the following steps:

a. Click the Edit button in the outlet’s Interval column. The outlet power up interval dialog

appears.

b. Enter a number of seconds in the Outlet N power

-up interval field.

c. Click OK.

4. Click Save and apply changes.

Configuring PC Cards

By selecting the Settings - PCMCIA menu option, the administrative user can use the PCMCIA

screen to insert, eject and configure PC cards. The following table shows how the three buttons on

this screen are used.

The following procedure describes the configuration steps to begin configuring any PC card.

To begin configuring a PC card:

1. Select the Settings

- PCMCIA menu option. The PCMCIA screen appears.

2. Click the Insert button on the line for the slot in which you are installing the PC card.

3. Insert the card into one of the slots on the front of the SP manager.

4. Click OK. The card type appears under the Card Type column.

5. Click the Configure button. The configuration dialog for the selected slot appears.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 239 240

Sin comentarios

Cyclades AlterPath BladeManager Manual de instrucciones Pagina 86