Cyclades AlterPath BladeManager Manual de instrucciones descargar pdf (Pagina 159)

Chapter 7: Using the cli Utility 145

cli Parameters and Arguments

The CLI configuration options are organized in a hierarchy called a parameter tree. You can use the

get, show and list commands to show parameters. You can also use the get command to show the

values of individual parameters at the end of a branch.

The following diagram illustrates one parameter in the SP manager cli parameter tree. As shown in

the example in Figure 7.1, each branch in the parameter tree is made up of one or more parameters,

one nested below the other. In the figure, the top

-level network parameter is followed by the

second

-level interface parameter, which is then followed by the third-level failover parameter. No

parameters are nested under failover.

Figure 7.1: Example Branch in the cli Parameter Tree

In this branch, the only commands supported are get and set. All of the parameters in a branch are

entered together on a single cli command line. For example, to get the value set for failover, you

would enter the following command:

Entering set with yes enables Ethernet failover; no disables it. To set failover, you would enter the

following command in interactive mode:

-- Signals the end of options and start of cli commands. If any are specified, cli goes into

command line or batch mode.

Table 7.1: cli Utility Options

Option Description

cli> get network interface failover

cli>

cli> set network interface failover yes

cli>

network

interface

failover

1 2 ... 154 155 156 157 158 159 160 161 162 163 164 ... 239 240

Sin comentarios

Cyclades AlterPath BladeManager Manual de instrucciones Pagina 159